AEM Adds Stabilizer Trim Actuator Capability

Monday, December 4, 2017

Contact: Tina Suckling, +44 1279 682311, tina.suckling@ametek.com

AEM Adds Stabilizer Trim Actuator Capability

STANSTED AIRPORT, ESSEX - AEM Limited, a unit of AMETEK Aerospace & Defense, now has new capability to test, repair and overhaul the stabilizer trim actuator for the Boeing 737 Classic and Boeing 737 Next Generation (NG) series aircraft platforms at its Ramsgate, Kent facility. This is a flight critical control system that maintains optimum horizontal stabilizer surface position during aircraft take-off, cruise and landing.

AEM has developed a full in-house capability, including a comprehensive test set-up to ensure all units meet the stringent performance criteria prescribed in the component maintenance manual. Part numbers for B737 Classic are 65-49970- series, 65C34751- series and 65C36486- series and for B737 NG 251A4510- series.

“AEM continues to add additional products to its capability, as part of its commitment to improve its service offering in response to customer demand,” comments Andy Wheeler, Commercial Director for AEM.

About AEM Limited
AEM Limited is among the largest independent aviation overhaul and repair facilities in Europe. Established in 1959, AEM provides accessory maintenance services for over 5,000 components from a variety of aircraft systems. It supports regional and international airlines, helicopter operators and airframe manufacturers from three UK-based facilities: Stansted Airport, Essex; Ramsgate, Kent; and Luton Airport, Bedfordshire. In addition to holding FAA and EASA approvals, AEM is an authorised repair station for Advanced Industries, Aeromedic, Astronics/DME Corporation, Eastern Aero Marine, KGS Electronics, Messier-Bugatti-Dowty, Safran Power, Tactair Fluid Controls, UTC Aerospace Systems Interiors, WINSLOW ® LifeRaft Company and Woodward HRT.

About AMETEK MRO
AMETEK MRO is a unit of AMETEK Aerospace & Defense and a global provider of repair and overhaul services for commercial, regional, general aviation and rotor-wing aircraft. Its operations are FAA, EASA, CAAC and CAAS approved. AMETEK MRO consists of AEM, Aeromedic, Ameron, AMETEK MRO Florida, AMETEK Singapore, Antavia, Avtech Avionics & Instruments, B&S Aircraft, Drake Air, Muirhead Avionics and Southern Aeroparts.

AMETEK MRO’s capabilities include avionic, electromechanical, electronic, fluid systems, hydraulic, oxygen, pneumatic and safety equipment components. AMETEK MRO also provides on-board first aid and medical kits and therapeutic oxygen. More information on AMETEK MRO can be found at www.ametekmro.com.  

AMETEK Aerospace and Defense is a division of AMETEK Inc, a leading global manufacturer of electronic instruments and electromechanical devices with annual sales of approximately $4 billion. For more information, contact AMETEK Aerospace & Defense, 50 Fordham Road, Wilmington, MA 01887, USA. Tel: +1 978 988 4639, aerosales@ametek.com, www.ametekaerodefense.com.